Filter
Top Products
16
17
Strip the insulating jacket of the cable back about .75
inch (18 mm) to reveal the individual hot and ground
wires within.
Remove a small amount of each individual wire’s
insulation (approximately .25 inch, 6 mm).
On the Euroblock plug, use a small screw driver to
loosen and open the sockets that will receive the
individual wires.
Insert the audio cable’s hot (+) wire into the matching
socket on the Euroblock plug.
Insert the audio cable’s cold (-) wire into the matching
socket on the Euroblock plug.
Insert the audio cable’s ground wire into the matching
socket on the Euroblock plug.
Tighten the screws on the wire sockets to secure the
individual wires.
Plug the completed Euroblock plug into the desired
output channel on the AV-P2.
At the other end of the cable, connect the hot (+) wire
to the unbalanced device’s hot connector.
Connect the cold (-) and ground wire to the unbalanced
device’s ground connector.
Connect the completed cable to your audio device.
Plug the completed Euroblock connectors into the AV-P2 audio output
jacks.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Setting Output Levels
Output levels on the AV-P2 are set with the DIP switches on the front
panel. Individual settings are possible for the left and right audio
channels.
LEFT
RIGHT
MUTE
CHANNEL
STEREO
PAIR
A-NET
ACTIVE
POWER
AV-P2
OUTPUT LEVELS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
ON
The AV-P2 front panel interface
To temporarily mute the output of the AV-P2 while adjustments are
being made, move the Mute switch to the left.