Filter
Top Products
26
27
Channels 1-16
Channels 17-32
EXPANSION OUT
EXPANSION OUT
To configure a 16 x 16 system:
Set up one input module (AV-M8, pair of AV-M8s, Y1
card, AN-16/i or AN-16/i-M) and one output module on
each side of the network.
Connect 16 mic- or line-level audio sources to inputs
1-16 on the first Pro16 Series input module.
Connect a Cat-5e cable from the A-Net out port on the
first input module to the A-Net expANsioN port on the
first output module.
Plug a Cat-5e cable into the A-Net iN port on the first
output module. This cable will be used to span up
to 500 feet/150 meters between the two sides of the
network.
Connect the cable from the A-Net iN port in Step 4 to
the A-Net out port on the second Pro16 Series input
module.
Connect the second group of 16 audio sources to
inputs 1-16 on the second Pro16 Series input module.
Connect a Cat-5e cable from the A-Net expANsioN port
on the second input module to A-Net iN on the second
Pro16 output module.
Patch the audio outputs from the two output modules
into the desired destinations.
Adding More Audio Outputs
As mentioned previously, the A-Net Out ports on AN-16/o and AV-P2
output modules and Personal Mixer products remain available even
1.
2.
3.
4.
5.
6.
7.
8.
POWER
ON
EXPANSION OUT
IN
AV-M8
STEREO LINK
CLOCK SOURCE
INTERNAL ADAT
CH 9-16
250VAC-F4AL
OUT
ADAT
®
POWER
ON
EXPANSION OUT
IN
AV-M8
STEREO LINK
CLOCK SOURCE
INTERNAL ADAT
CH 9-16
250VAC-F4AL
OUT
ADAT
®
Channels 1-16 in
Channels 17-32 in
Channels 1-16 out
Channels 17-32 out
Note that A-Net In is connected to A-Net Out on both pairs of modules
in this 32 x 0 system.
The AV-P2 can be substituted for the output module that supplies
channels 17-32 if desired. It cannot be substituted for the output module
supplying channels 1-16 because the AV-P2 does not have the A-Net
Expansion port.
16 Channels Send by 16 Channels Return
The 16 x 16 configuration has 16 inputs and 16 outputs on each side of
the audio network.
A
-N
e
t
A-NetExpansion
Pro16 Output
Pro16 Input
Pro16 Output
Pro16 Input
Channels 1-16 In Channels 1-16 Out
Channels 17-32 InChannels 17-32 Out
Using this configuration, each side of the audio network has one input
module and one Pro16 output module. Sixteen channels of audio move
in each direction over a single Cat-5e cable.
The AV-P2 can be used to output channels 17-32 in this diagram. It
cannot be substituted for the output module supplying channels 1-16
because the AV-P2 does not have the A-Net Expansion port.
Again, the A-Net Expansion port is used to combine the A-Net data from
two devices for transmission over one Cat-5e cable.