Filter
Top Products
8
MINICOM COM800
+ Merely switching the unit off does not mean that it is fully disconnected from the
mains. To disconnect the unit from the mains, pull out the mains connector. Please
make sure before installation that the mains connector has not been damaged. If
you do not use the unit for an extended period of time, please disconnect it at the
mains.
2.2 The rear
Fig. 2.2: Rear panel connectors of the COM800
The COM800 is connected to the mains using a 2-pole POWER connector jack. A matching
mains adaptor is included with the unit.
+ Always use the mains adaptor supplied with the unit to avoid damage to your
COM800.
The two OUTPUT connectors are on 1/4" jacks and provide an unbalanced left/right signal.
When you select a mono preset, both jacks will provide the same mono signal.
The I/O LEVEL switch determines the level used by the signal processing circuitry of the
COM800: -10 dBV (home recording level) or +4 dBu (studio level).
+ Make sure to set the correct reference level that matches the operating level used
by other equipment connected. Otherwise, distortion may be caused and your
COM800 will not function optimally (see chapter 4.1).
The two INPUT connectors are on 1/4" jacks. Always use balanced patch cords with 1/4" plugs
or standard insert cables (unbalanced connection). Mono signals should be connected to the
L jack.
SERIAL NUMBER.
2. CONTROL ELEMENTS AND CONNECTIONS