Filter
Top Products
8
V-AMPIRE LX110
4. PRESETS
2.2 Rear panel
Fig. 2.3: Operating elements of the V-AMPIRE (rear panel)
SERIAL NUMBER.
FUSE HOLDER/VOLTAGE SELECTOR. Before
connecting the unit to the mains, ensure that the voltage
setting matches your local voltage.
A blown fuse should only be replaced by a fuse of the
same type and rating. On some units, the fuse holder can
be switched to one of two positions, i.e. 230 V and 120 V.
Please note that when operating the unit outside Europe at
120 V, a higher fuse rating is required (see Chapter
“9. SPECIFICATIONS”).
The mains connection is on an IEC receptacle. A suitable
power cord is included with the unit.
Use the POWER switch to operate the V-AMPIRE. The
POWER switch should always be in the OFF position (out)
when connecting the unit to the mains.
The POWER switch does not fully disconnect the
unit from the mains. To disconnect the unit from
the mains, pull out the mains connector. When
installing the product, ensure that the mains
connector has not been damaged. Unplug the power
cord completely when the unit is not used for long
period of time.
3. APPLICATION EXAMPLE
Fig. 3.1 shows an example of how to use the V-AMPIRE LX110.
When you connect headphones (thereby muting the speaker)
and a CD player or drum computer, you get an ideal setup for
practising at home.
Fig. 3.1: Practice setup
4. PRESETS
Your V-AMPIRE features 100 rewritable presets (00 – 99). After
power-up the last preset used is automatically recalled. Each
preset consists of a maximum of 6 “ingredients”:
V one amp simulation,
V pre-amp effects (noise gate, compressor, wah-wah),
V tunable treble and bass EQs,
V one modulation effect (e.g. phaser, chorus, etc.),
V one delay effect, and
V one reverb effect.
4.1 Editing presets
Editing presets on the V-AMPIRE is quick and easy, simply follow
the instructions below:
V First, determine the global gain by pressing the DELAY and
MODUL buttons simultaneously. Then use the ADJUST
control to set the gain. If required, use the UP and DOWN
buttons to activate an additional filter preset for optimizing
the basic sound. Press DELAY and MODUL again to quit
this menu.
V Select a preset with the UP and DOWN buttons.
V Then, select an amp model with the FX/AMP control. The
EDIT LED on the display lights up to indicate that you are
editing the preset.