Filter
Top Products
EURODESK SX4882
Connections12
Connections7.
Rear panel7.1
Expander port bus inputs
If you want to add another console to your EURODESK SX4882,
the expander port bus inputs give access to all subgroups, auxes
and mix busses via an array of 1/4" jacks, situated top left on the
rear panel.
Expander port bus inputsFig. 7.1:
Auxiliary sends
Unbalanced 1/4" jacks, wired tip = signal (+ve) and sleeve =
ground/screen. They operate at +4 dBu.
Auxiliary sendsFig. 7.2:
Auxiliary returns
All six stereo pairs, to be located immediately below the aux sends,
are on unbalanced 1/4" jacks and operate at 0 dBu.
Auxiliary returnsFig. 7.3:
Subgroup inserts
Unbalanced send and return from a single stereo jack socket,
wired tip = out, ring = in and sleeve = ground/screen.
Subgroup insertsFig. 7.4:
2-track in/out
RCA sockets for use with tape recorders, etc., signal = main mix,
wired center post = signal (+ve) and sleeve = ground/screen.
2-track in/outFig. 7.5:
2-track/external inputs
Two additional stereo inputs, this time on unbalanced 1/4" jacks,
wired tip = signal (+ve) and sleeve = ground/screen.
Additional connectorsFig. 7.6:
Main inserts
As above, but for the main mix.
Stereo outputs
The control room output (monitors) main mix, MIX-B and studio
output are all on a pair of unbalanced 1/4" jacks, nominal output
level +4 dBu. The main mix is also available as a fully balanced
pair.
Phones 1/2
These are on stereo jacks, wired tip = left signal, ring = right signal
and sleeve = ground/screen (see section 6.4 “Headphones”).
Meter/analyzer out
Unbalanced jacks at +4 dBu for use with external measur-
ing equipment, e.g. the built-in real-time analyzer of our
BEHRINGER ULTRACURVE PRO DEQ2496 (signal = master
LED meters).
Master balanced outputs
Balanced XLR for connecting to the mastering recorder. Wired
pin 1 ground/screen, pin 2 hot and pin 3 cold. Maximum level is
+28 dBu.
Main balanced outputsFig. 7.7: