Filter
Top Products
{CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After installing the seat, always check to be
sure that the safety belts are properly routed
and attached, and are not twisted.
Do not put the third row seat in so it faces rearward
because it will not latch that way. The seat has to go in
before the convenience center. See Convenience
Center on page 2-56 for more information.
For ease of installing the seat, put the seat in the folded
position before beginning this procedure.
1. From the rear of the vehicle, place the front hooks of
the seat onto the front floor pins in the third row. To
do this, the seat will need to be angled approximately
8-10 inches (20-25 cm) from the floor so the front
hooks clear the rear floor pins and rear floor cups.
Use the release handle to guide the seat into place.
If the front hooks are not attached correctly, the
rear latches will not attach to the rear set of
floor pins.
2. Firmly push the rear latches into the rear floor pins
by pushing down on the rear of the seat.
3. Try to raise the seat to make sure that it is locked
down. The indicator pins will no longer stick out
when the seat is properly latched into place.
{CAUTION:
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
push and pull on the seatback to be sure it is
locked.
4. Return the seatback to its upright position. See
“Returning the Seatback to an Upright Position”
earlier in this section.
1-13