Filter
Top Products
E-32
Getting Ready
Before assembling the stand, first take a few moments
to check that all of the items shown below are present.
• This stand does not include any of the tools required
for assembly. It is up to you to prepare a large
Philips head (+) screwdriver for assembly.
Before starting assembly, check to make sure that you
have all the parts shown below. You can find the
screws in a plastic bag inside of the polystyrene foam
packing material.
*
CAUTION
• Assembly of the stand should be performed by
at least two people working together.
• This stand should be assembled on a flat
surface.
• Do not remove the tape from the locations
shown in the nearby illustration until you finish
assembling the stand. Removing the tape before
assembly is complete is very dangerous
because it allows the keyboard cover to open
and close, creating the risk of pinching your
fingers between the cover and the Digital Piano.
• Take care that you do not pinch your fingers
between parts when assembling them.
• When placing the Digital Piano on the floor, be
sure to place it on something soft (a blanket,
cushion, etc.). Do not place the Digital Piano
directly onto the floor.
1.
Unfasten the band that fastens the pedal cord
to the back of the pedal unit
E
and extend
the pedal cord.
Assembling the Stand
A
B
F
G
M
N
(a) (b)
O
H
I
J
K
L
Q
R
S
T
U
P
C
D
E
A
Side panel...........................×1
B
Side panel...........................×1
C
Back panel ..........................×1
D
Back panel ..........................×1
E
Pedal unit............................×1
F
Screws ................................×8
G
Screw caps..........................×8
H
Screws ................................×2
I
Screws ................................×5
J
Screws ................................×3
K
Screws ................................×2
L
Clips....................................×2
M
-(a) Bracket.......................... ×1
M
-(b) Bracket.......................... ×1
N
Brackets.............................. ×2
O
Screw caps ......................... ×2
P
Joint connectors..................×6
Q
Polystyrene foam packing
material (Required for stand
assembly.)........................... ×1
R
Headphones hook............... ×1
S
Screw.................................. ×1
T
Keyboard cover spacer....... ×1
U
Keyboard spacer hook........ ×1
Tape Tape
Pedal cable
PX830_03_e.fm 32 ページ ２００９年７月１７日 金曜日 午前１０時４８分