Filter
Top Products
23
GENERAL SPECIFICATIONS
*0dB=0.775Vrms, 0dBV=1VRMS
Maximum Output Level
(0.5% T.H.D. at 1kHz)
+26dB (MAIN L/R), +20dB (ALT 3/4, AUX, EFX, CTRL ROOM)
+20dB (INSERT) more than 100mW (HEADPHONES) @ 33Ω
T.H.D.
<0.1% @ +14dB 20Hz~20kHz (MAIN L/R, ALT 3/4, AUX SEND, EFX SEND, CTRL ROOM)
Frequency Response
20Hz~20kHz, +1/-2dB (MIX L/R, ALT 3/4, AUX SEND, EFX SEND, CTRL ROOM)
Hum and Noise (Average,
20kHz LPF Rs = 150Ω)
-127dB equivalent input noise, -95dB residual noise (MAIN L/R, ALT 3/4, AUX/EFX SEND,
CTRL ROOM OUT), -88dB (MAIN L/R, ALT 3/4, AUX/EFX send, CTRL ROOM OUT) * Master
fader at nominal level and all channel fader Minimum.
Maximum Voltage Gain
74dB MIC IN to MAIN L/R, 74dB MIC IN to ALT 3/4, 66dB MIC IN to AUX (PRE)
76dB MIC IN to AUX (POST), 76dB MIC IN to EFX (REV), 80dB MIC IN TO CONTROL ROOM
52.5dB MIC IN to REC L/R, 54dB LINE IN to MAIN L/R, 54dB LINE IN to ALT 3/4
46dB LINE IN to AUX (PRE), 56dB LINE IN to AUX (POST), 56dB LINE IN to EFX (REV),
60dB LINE IN to CONTROL ROOM L/R, 44dB ST IN to MAIN L/R, 44dB ST IN to ALT 3/4
16dB AUX RETURN IN to MAIN L/R, 20dB TAPE IN to MAIN L/R
Crosstalk (at 1kHz)
-70dB between input channels, -70dB between input/output channels
Gain Control (mono Input
channel)
44dB Variable (-50dB ~ -6dB), (-30dB ~ +14dB)
Gain Control (mono/stereo
combination Input channel)
40dB Variable (-20dB ~ +20dB)
Input Channel Equalization
HIGH: 12kHz shelving, MID: 2.5kHz peaking, LOW: 80Hz shelving * turnover/roll off
frequencies: located 3dB below maximum boost/cut
LED Meters
10-segment LED x2 MAIN L/R, ALT 3/4, PFL, TAPE IN
Channel Indicators
Peak: An indicator for each channel turns on when the pre-channel fader signal is 5dB
below clipping.
Phantom Power
+48V DC
Power Supply
USA/Canada 120VAC / 60Hz
Australia 240VAC / 50Hz
Europe 230VAC / 50Hz
Power Consumption
36W
Weight
3.4 kg (7.5 lbs) CVM-1224FXUSB
5.6 kg (12.3 lbs) CVM-1624FXUSB
Dimension (W x H x D)
328 x 90 x 420 mm (12.9 x 3.5 x 16.5 in) CVM-1224FXUSB
436 x 90 x 420 mm (17.2 x 3.5 x 16.5 in) CVM-1624FXUSB
*Specifications and design subject to change without notice for improvements.