Filter
Top Products
128
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Glossary
Clipping
A condition in which a signal level exceeds the maximum level a circuit
can handle. This is usually caused by improper gating parameters and gain settings.
It causes distortion and typically leads to listener fatigue and accelerated failure of
loudspeaker drivers.
Compression
An induced reduction in the dynamic range of part or all of an audio
signal. Compression is usually used to protect individual loudspeaker components
from the damaging effects of transients.
Compressor
The compressor is part of the processing settings and allows you to
change the gain transfer characteristics of the signal path and to control the
dynamics of the signal.
Configuration mode
Configuration mode is the default mode in G-Ware and is
used for system setup. It provides access to the Matrix and Flow Screens. See also
Preset mode and Macro mode.
Control bus
Part of the expansion bus, the control bus passes control information
to the units. Control is not affected by master/slave settings and will continue to
function even if the units are not using the audio channels.
Constant Directivity Horn Equalizer (CD Horn EQ)
Horn drivers commonly
used in arrays in arenas and auditoriums have an inherent 6dB/octave high frequency
rolloff. The PSR1212’s CD Horn EQ compensates for this characteristic.
Crossover
A device that passes designated frequency segments of an audio signal to
various loudspeaker elements in a sound system.
• Bessel A crossover using a low-pass filter design characterized by a linear
phase response. This results in a constant time delay throughout the passband.
• Butterworth A crossover using a low-pass filter design characterized by a
maximally flat magnitude response. This results in no amplitude ripple in the
passband.
• Linkwitz-Riley A fourth-order crossover consisting of a cascaded second-
order Butterworth low-pass filter. Offers a vast improvement over the
Butterworth crossover and is the de facto standard for professional audio
active crossovers.
Cross point
The intersection between an input and an output in the routing matrix.
Cross point cells are colored according to input type.
Cross point attenuation
The process of attenuating audio level at the cross point.
Audio can be attenuated from 0 to 60dB.