Filter
Top Products
57
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Advanced Configuration ~ Presets
To create a preset
1. From the Preset Selection list, select the number of the preset you will be
configuring. Enter a description of the preset in the Preset Description box.
2. If you want to password protect this preset, click Protected. See page 26
for information on creating the preset password.
3. Configure the routing matrix and make cross point attenuation adjustments.
4. Configure input, output, and processing channel settings as needed. See
Chapter 3: System Configuration for specific instructions on unit settings.
5. Click Gating Controls to set up gating parameters for the preset.
6. Make GPIO or Remote assignments as needed.
7. Click Virtual Reference if you need to create Virtual References specific to
the preset.
8. When you have finished configuring the preset, click Save Preset to save
the settings. Click Exit Preset to exit Preset Mode.
Storage space
In a realistic preset configuration scenario, it is highly unlikely that you would reach
the storage capacity of the unit. In the event that you exceed the preset storage
space, G-Ware will alert you when you try to save the preset. You will be asked to
reduce the number of cross point changes or the number of macros in the preset. As
a general rule, if you make cross point changes to three-fourths of the matrix, you
can establish a maximum of 128 nested macros for a given preset.