Filter
Top Products
Front panel features
Mix Send features
The XRM is capable of generating 12 mono mixes, 6 stereo mixes, or a combination of both
mono and stereo mixes. Each of the six Odd/Even pairs of sends can be configured as a stereo
pair- the Odd pot becomes the level control, the Even pot becomes the pan pot.The changeover
to stereo operation is controlled by the STR PAIR switches located above the master faders.A
LO CUT switch is also present for activating the hi-pass filter (40Hz, -18dB/oct) for each pair of
mixes.
Mix 1 - 4 PRE
MIX Sends 1-4 are Post-Fader
MIX Sends 1-4 are Pre-Fader
Normally, the signal feeding the Mix Sends is derived after the main Chan Level Pot (Post-Fader).
This Chan Level pot controls the level of the chan signal feeding the individual Mix Send pots.
Each Mix Send pot is then used to generate a sub-mix of this channel signal.This Post-fader signal
is also affected by the Mute switch; if the channel is muted, the Mix Send no longer receives a sig-
nal.There are some cases where an independent mix is desired, the operator doesn’t want the
Chan Level to affect the signal. On the XRM, Mixes 1 thru 4 can be switched to receive their sig-
nal PRE the Chan Level pot (Pre-fader).The default PRE setting for Mixes 1-4 is pre-fader, but it is
still post-insert/post-EQ/post Mute. An internal jumper (per channel) can be changed so that the
PRE setting becomes either pre-insert or pre-EQ.Another jumper allows this PRE setting to addi-
tionally be independent of the channel mute.
Mix Sends 1 & 2
Levels for Mixes 1 and 2 are controlled by this pair of knobs. In MONO mode, each knob con-
trols the amount of chan signal that is sent to its corresponding mix bus. In Stereo Mode, the top
knob controls the level to both buses and the bottom knob acts as a PAN control between the
two buses- full CCW for Odd, full CW for Even.
STR PAIR sw in the UP position(located above Master Fader 1)
Knob 1: Send level for Mix 1
Knob 2: Send level for Mix 2
STR PAIR sw in the DOWN position
Knob 1: Send level for both Mix 1 and Mix 2
Knob 2: Pan control between Mix 1 and Mix 2
This Send arrangement is repeated for the remainder of the Mix Send
pairs on the channel. Each pair’s operation is controlled by its own STR
PAIR switch located above the corresponding odd-numbered Master
Fader.
p.11
Mono Input channel
1