Filter
Top Products
10
ENGLISH
6
FADER START
If the separately sold DN-S5000, DN-S3500, DN-D9000, DN-D4500 and etc. players are connected to LINE2, 4,
6 or 8, they can be started using the source input fader (Ch. Fader) or Crossfader, as long as the 3.5 mm stereo
mini cords have been connected.
LINE 2 LINE 4 LINE 6 LINE 8
FADER
LINE 2
FADER
LINE 4
FADER
LINE 6
FADER
LINE 8
DN-X1500S
MAIN ALPHA
FADER
MAIN
FADER
ALPHA
DN-S5000
CD1
MAIN ALPHA
FADER
MAIN
FADER
ALPHA
DN-S5000
CD2
3.5 mm stereo mini cord
RCA cord
Channel Fader Start
Turn the INPUT ASSIGN
switch #4 to select the
desired source from LINE2,
4, 6 or 8.
1
2
Crossfader Start
NOTE:
• Channel Fader Start and Crossfader Start for the
same source will not operate simultaneously.
You must select from either one. If both CH
FADER START and CROSSFADER START A, B
switches are ON, priority will be the cross fader.
Turn on the CH FADER START
switch @6.
3
Move the source input fader
(Ch. Fader) !9 of CH-1, CH-2,
CH-3 or CH-4 control all the
way to the bottom.
4
Set the standby mode on CD player.
5
When you want to start the
player, move up the source
input fader (Ch. Fader) !9 and
the CD player will begin
playing.
Turn the INPUT ASSIGN
switch #4 to select the
desired source from LINE2,
4, 6 or 8.
1
2
Using the CROSSFADER
ASSIGN switch !0, assign the
channel or Sampler source into A
or B of Crossfader.
3
Turn on the CROSSFADER START A, B
switches !7.
5
Set the standby mode on CD player.
6
Use the CROSSFADER CONTOUR control @0
to control the cross fader startup curve.
4
Slide the Crossfader !8 all the way in direction
opposite the source you want to start. (In the
following example, startup is done with the CD
player connected set to Assign A.)
7
When the Crossfader !8 is slid in the opposite
direction, CD player play will begin.
1. Remove the crossfader from the set.
2. Move the lever so that the head of the screw is positioned at the hole in the case.
3. Turn the screw using a screwdriver, move the lever and adjust to the desired torque.
4. Reinstall the crossfader following the removal procedure in reverse order.
2 FLEX FADER CROSSFADER SLIDE TORQUE ADJUSTMENT PROCEDURE