Filter
Top Products
11
4. Headphones
Connect a pair of stereo headphones to this 1/8" jack. For proper frequency response, the Amp/
Mixer switch should be set to Mixer (“In” position) when using headphones.
Note: The Headphones output can have either a mono or stereo signal, depending on what 1/4"
outputs are connected. If neither (or both) 1/4" outputs are connected, the Headphones output
will be in stereo. If a cable is connected to the Left (Mono) 1/4" output only, the Headphones
output will be in mono.
5. Aux In
Connect the headphone output of an MP3 or CD player using a stereo 1/8" cable to this 1/8"
stereo TRS jack for rehearsing with your favorite pre-recorded material. Adjust the output level
of your playback device and the RP255’s Master Level knob for the proper volume balance.
6. USB Port
The USB port is for connecting the RP255 to a computer and serves two purposes: (1) for use with
the downloadable X-Edit™ Editor/Librarian software, and (2) for streaming audio to and from the
computer when using the included Cubase
®
LE 4 software. Audio streaming is limited to 2 chan-
nels up and 2 channels down from the computer at 44.1kHz, 16 bit and 24 bit. A utility panel in
the Editor/Librarian controls the direct/playback mix with any recording software the RP255 is con-
nected to. Knobs2 and 3 also control the direct/playback mix and USB record level when USB is
connected and the Pickup Row is selected.
Note: You can download the X-Edit Editor/Librarian software and USB drivers at www.digitech.
com.
7. Power Input
Connect only the DigiTech
®
PS0913B power supply to this jack.