Filter
Top Products
Operation
This section of the manual provides information on:
z HDMI DA2 Front Panel Features
z EDID Minder
HDMI DA2 Front Panel Features
HDMI DA2
CONFIG
INPUT
EDID
OUTPUTS
12
SIGNAL
HDCP
1
2
4 5
3
Figure 7. HDMI DA2 Front Panel
a
Power status LED
b
USB Config port
c
Signal LEDs
d
HDCP LEDs
e
EDID LED
Power Status LED
The power status LED lights green when power is applied to the unit.
USB Config Port
The USB Config port is used for SIS configuration, monitoring, and firmware updates. This
port can be used as an alternative to the rear panel RS‑232 captive screw connectors.
NOTES:
• Neither port has precedence and commands from either port are handled in the
order they are received.
• Extron recommends that the USB port is used for temporary connections. If a
permanent connection is required, the RS‑232 port should be used.
When the USB Config Port is connected to the HDMI DA2 for the first time, the Found
New Hardware Wizard opens to install the correct device driver (see Connecting to the
USB Port on page 7).
HDMIDA2 • Operation 10