35
Standard programs
5.2.6.4 Network setup
The instrument supports communication in local networks. For
the setup of an Ethernet communication in networks, a special
configuration is required. The manufacturer recommends support
from a network administrator. Only use a shielded cable
(e.g. STP, FTP, S/FTP) with a maximum length of 20 m for the
Ethernet port. This section describes the setting options for the
photometer in relation to network communication.
The connection parameters must be configured for data transfer
to a PC or connection to a network.
1. Press PC & Printer in "Instrument Setup".
2. Press Network > Setup.
3. Press On and then LCS IV IP: Automatic.
4. Press IP address.
An IP address is used to send data from a sender to a
pre-defined recipient.
• If the IP for the instrument is automatically assigned in
the network, no further settings are necessary. A
hostname can optionally be assigned.
• If the instrument address is fixed, the connection must be
configured.
5. To configure the IP address, press Fix.
6. Press IP address and enter the address.