Filter
Top Products
-16-
H8068 Telecaster
®
Style Kit
Wiring Pickups
This guitar comes with a control plate that has
most of the components soldered in place. You
only need to solder the pickup wires onto the
three way switch and volume control. If done
incorrectly, soldering the wires may cause dam
-
age to the components. If you are unsure of your
skills; do your research, practice on scrap wires,
or take it to a professional.
Components and Hardware Needed: Qty
Guitar Body .......................................................
1
Control Plate ......................................................
1
Pick Guard .........................................................
1
Bridge ............................................................... 1
To wire the pickups:
1. Remove the bridge and control plate.
2. Thread the pick guard pickup and bridge
pickup wires through the channels and holes
into the control plate cavity as shown in
Figure 21.
Figure 21. Wires threaded through body.
Output
Jack
Ground
Wire
Pick
Guard
Wires
Bridge
Wires
Control
Plate
Cavity
Bridge
Cavity
3. Thread the ground wire through the hole in
the control plate cavity into the bridge cavity
(Figure 21).
4. Push the audio jack out through the hole in
the end of the body.
5. Solder the pickup wires onto the volume and
three way switch as shown in the
Wiring
Diagram on Page 29 and the Electrical
Photos on Pages 27-28.
6.
Remove the plastic wrapping on the pick
guard, if you have not already done so.
7.
Fasten the pick guard to the body with the #3
x
3
/8" screws. Do not fasten the control plate
or bridge yet.