Filter
Top Products
H8068 Telecaster
®
Style Kit
-17-
Installing Output
Jack
Components and Hardware Needed: Qty
Output Jack .......................................................
1
Output Jack Cover .............................................
1
Stainless Steel Screws #3 x
3
/8"
........................ 2
To install the output jack:
1. Thread the output jack onto the jack cover.
2. Place the output jack cover in the jack cavity,
and mark the mounting holes.
3. Using a
1
/16" drill bit, drill
3
/8" holes at a 45º
angle into the body as shown in
Figure 22.
Figure 22. Drilling output jack mounting holes.
4. Mount the output jack cover with two
#3 x
3
/8"
screws.
Installing Bridge and
Control Plate
Figure 23. Ground wire above bridge cavity.
3. Secure the bridge with the #5 x
5
/8" screws
and the control plate with the #4 x
15
/16"
screws.
To reduce humming, the ground wire must contact
the bridge plate.
Components and Hardware Needed: Qty
Guitar Body .......................................................
1
Bridge ................................................................ 1
Control Plate ......................................................
1
Stainless Steel Screws #5 x
5
/8" ........................ 4
Stainless Steel Screws #4 x
15
/16" ..................... 2
To position the ground wire under the bridge:
1. Place the exposed end of the ground wire
above the bridge cavity (see
Figure 23), and
place the bridge over it so the bridge and wire
make contact.
2. Tape the ground wire in the bridge cavity to
keep the exposed portion from moving.
Ground Wire