Filter
Top Products
9
If the cover panel comes open as shown below after you’ve
attached it, apply gentle pressure to the rear side and fit
the projections of the cover panel into the slot of the rear
rail.
Moving precautions
If you transport the keyboard assembly with the module in
the raised position, the lock plate must be fitted into the
slot on the bracket and secured in place by tightening the
lockplate screw. If you transport the keyboard assembly
with the module in the lowered (storage) position, the latch
must be connected to the module, with both the module
and bracket screws securely fastened.
If you transport the system without fastening these
screws, the module may move abruptly, causing dam-
age or injury.
Module raised
Module lowered (storage position)
Caution when using multiple modules
■ When using more than one module, be sure both mod-
ules are turned off before connecting or disconnecting
either of the cables connected to the TO MODULE and
TO MODULE (2nd) connectors.
■ When using more than one module, the module con-
nected to the TO MODULE connector must be turned on
in order for the module connected to the TO MODULE
(2nd) connector to be detected by the keyboard assem-
bly and to function properly.
■ The lit/dark status of SW1/SW2 will reflect the state of
the module connected to the TO MODULE connector.
The SW1/SW2 lit/dark status of the module connected
to the TO MODULE (2nd) connector will not be reflected.
Be aware that the state of the TO MODULE (2nd) unit
may not necessarily match the SW1/SW2 status. If you
want the lit/dark indication to match the state of the TO
MODULE (2nd) unit, you would need to set the On/Off
and Toggle/Momentary setting of each Program, Com-
bination, or Song of the module connected to the TO
MODULE (2nd) connector to be identical to the settings
of the module connected to the TO MODULE connector.
■ The Global mode menu command “After Touch Calibra-
tion” cannot be selected from an M3-M connected to the
TO MODULE (2nd) connector. In order to execute this
command, the M3-M must be connected to the TO MOD-
ULE connector.
Specifications
Keyboard 73-key: semi-weighted
88-key: RH-3 (Real Weighted
Hammer Action 3)
Controllers Joystick
Ribbon controller
SW1/SW2
Control connector TO MODULE connector
TO MODULE(2nd) connector
Dimensions (W x D x H) 73-key: 1189 x 371 x 128 mm
46.8 x 14.6 x 5.0 inches
88-key: 1425 x 442 x 128 mm
56.1 x 17.4 x 5.0 inches
Weight 73-key: 12.5 kg / 27.6 lbs.
(including cover panels and lock-
ing support)
88-key: 21.7 kg / 47.8 lbs.
(including cover panels and lock-
ing support)
Included items Connection cable x 1
* Appearance and specifications of this product are subject
to change without notice.