Filter
Top Products
188
Effects
Pitch/Phase Mod.
b: LFO Shape
Changing the LFO waveform shape controls the peak
sweep of flanging effects.
g: Feedback, h: Wet/Dry
The peak shape of the positive and negative “Feedback”
value is different. The harmonics will be emphasized
when the effect sound is mixed with the dry sound if you
set a positive value for both “Feedback” and “Wet/Dry”,
and if you set a negative value for both “Feedback” and
“Wet/Dry”.
g: High Damp [%]
This parameter sets the amount of damping of the feed-
back in the high range. Increasing the value will cut high-
range harmonics.
021: RandomFlang
(Stereo Random Flanger)
The stereo effect uses a step-shape waveform and random
LFO for modulation, creating a unique flanging effect.
022: Envel.Flang
(Stereo Envelope Flanger)
This Flanger uses an envelope generator for modulation. You
will obtain the same pattern of flanging each time you play.
You can also control the Flanger directly using the modula-
tion source.
c: Sweep Mode, c: Src
This parameter switches the flanger control mode. With
“Sweep Mode” = EG, the flanger will sweep using the
envelope generator. This envelope generator is included
in the envelope flanger, and not related to the Pitch EG,
Filter EG, or Amp EG.
a
Delay Time [msec]
Sets the delay time from the original sound
0.0...50.0msec
b
LFO Waveform
Selects LFO Waveform
Step-Tri, Random
☞ Fx:010
c
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right
☞ Fx:010
d
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed
☞ Fx:010,
Src Off...Tempo
Selects the modulation source used for both LFO speed and step speed
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
e
LFO Step Freq (Frequency) [Hz] 0.05...50.00Hz
Sets the LFO step speed (speed that changes in steps)
☞ Fx:010,
Amt –50.00...+50.00Hz
Sets the modulation amount of LFO step speed
f
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
tempo and notes
☞ Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞ Fx:009, 010
Base Note
Selects the type of notes that specify the LFO speed ☞ Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed
☞ Fx:009
g
Step Base Note
Selects the type of notes to specify the LFO step speed
☞ Fx:010,
Times x1...x32
Sets the number of notes to specify the LFO step speed
☞ Fx:010
h
Depth
Sets the depth of LFO modulation
0...100
LFO Shape
LFO Shape = 0...+100
LFO Shape = 0...–100
LFO Waveform=Sine
LFO: Step-Tri/Random
Left
Right
Feedback
LFO Phase
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Flanger
Flanger
i
Feedback
Sets the feedback amount
–100...+100
☞ Fx:020
High Damp [%] 0...100%
Sets the feedback damping amount in the high range
☞ Fx:020
j
Wet/Dry –Wet...–1:99, Dry, 1:99...Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
☞ Fx:010, 020,
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
a
L Dly Bottom [msec] (L Delay Bottom)0.0...50.0msec
Sets the lower limit of the delay time on the left channel
☞ Fx:009
L Dly Top [msec] (L Delay Top)0.0...50.0msec
Sets the upper limit of the delay time on the left channel
☞ Fx:009
b
R Dly Bottom [msec] (R Delay Bottom)0.0...50.0msec
Sets the lower limit of the delay time on the right channel
☞ Fx:009
R Dly Top [msec] (R Delay Top)0.0...50.0msec
Sets the upper limit of the delay time on the right channel
☞ Fx:009
c
Sweep ModeEG, D-mod
Determines whether the flanger is controlled by the envelope gen-
erator or by the modulation source
☞,
SrcOff...Tempo
Selects the modulation source that triggers the EG (when EG is
selected for Sweep Mode), or modulation source that causes the
flanger to sweep (when D-mod is selected for Sweep Mode)
☞
d
EG Attack
Sets the EG attack speed
1...100
☞
EG Decay
Sets the EG decay speed
1...100
☞
e
Feedback
Sets the feedback amount
–100...+100
☞ Fx:020
f
High Damp [%]0...100%
Sets the feedback damping amount in the high range
☞ Fx:020
g
Wet/Dry–Wet...–1:99, Dry, 1:99...Wet
Table , “Sets the balance between the effect and dry sounds,” on
page 175
☞010, 020,
SrcOff...Tempo
Table , “Selects the modulation source of the effect balance,” on
page 175
Amt
Table , “Sets the modulation amount of the
effect balance,” on page 175
–100...+100
EG Attack/Decay
EG
D-mod
Sweep Mode
D
-mod
Flanger
Flanger
Left
Right
Feedback
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out