Filter
Top Products
Note: Care should be taken in selecting the type of cable used to link the digital
source to your processor. If coaxialcable is to be used, it should be non-capacitive
and have a bandwidth in excess of 1OMHZ to prevent drop out errors. If available,
we strongly recommend fiber optics for their ability to completely isolate all
grounding between components, thereby preventing any player/processor
ground loop interferences.
Analog Outputs
1.Using either the single ended or balanced output on the SBP-64X make the
connections between the processor and any high level input on your preamplifier.
Be certain to maintain L/R consistency between the cables or you will accidentally
reverse your stereo image.
Note: The SBP-64X outputs should be run directly to a high level stage of your
preamp without any input filtering.
INITIAL POWER UP
1.
Plug the power supply AC cord into the wall socket. DO NOT PLUG YOUR
AMPLIFIER IN YET!
2. Turn your digital source (CD/DAT/Satellite) "ON".
3.Turn the power supply switch to the "ON" (UP) position, and turn "ON" your
digital signal source. Whether it is CD/DAT or Satellite is not important. The
following results should occur in this particular sequence:
A. The three ZEO’s designating Digital, Analog, and DAC power will illuminate
simultaneously. This is your assurance that the five individual power supplies
are operating and stable.
B. After a period of 5 to 20 seconds, the DACs will stabilize and the LED
corresponding to the Sampling Frequency of your digital source will illuminate.
Caution: Should you have any major deviation from this sequence, do not
attempt to play the unit. Disconnect it prior to powering up any other
components attd contact your Krell Digital dealer immediately.
4. You may now connect your amplifier to the AC mains and power up your compo-
nents, remembering that the last component to be energized should be your
amplifier.
5.
With your volume set low, switch the source selector of your preamp to the position
correlating to your chosen input connection for the SBP-64X (i.e. AUX, CO, DAT,...)
6. Begin playing your Compact Disk or Digital Audio Tape.
Note: While your SBP-64X will perform beautifully from the moment you turn it
on, it requires a minimum warm up period of 8 hours before it will reach its full
sonic potential.
Your installation is now complete. Should you have any further questions which
are not covered in the ~emainder of this reference, contact your authorized KDI
dealer. We wish you man~ hours of listening fulfillment!
SBP-64X INSTALL ION QUESTIONS AND ANSWERS ,,, ,,,,,, ,,,
Q.
My CD player has both fiber optic and coax/al outputs. Which one shoul~
I use?
A.
Given a choice, we prefer the optical link due to its ability to completely isolate
the grounds between two components. This eliminates the possibility of ground
loops in the digital components.