Mackie PPM1008 DJ Equipment User Manual


 
7
Owner’s Manual
Owner’s Manual
House of Worship System
This diagram shows microphones attached to the mic inputs of channels 1 to 4, an electric guitar con-
nected directly to channel 5 (with hi-z switch pressed in), an acoustic guitar mic connected to channel 6
mic in, a keyboard attached to channel 7's stereo inputs, and a drum machine to channel 8.
A Mackie SRM150 powered monitor is connected to the monitor 1 send, and acts as a personal stage
monitor to the keyboard player. The mon 1 knobs of each channel allow you to set up a monitor mix that
is independent of the main mix.
The power amp mode switch is set to play the mono main mix on ch. A, and monitor 1 mix on ch. B.
Passive speakers are connected to the channel A speaker-level power output of the powered mixer, and
they play the main mono mix to your audience.
Passive subwoofers are powered by an amplifier connected to the main mix sub out, to reinforce the
low end in your main mix.
C300z passive stage monitors are connected to the channel B speaker-level power output of the pow-
ered mixer. These play the stage monitor mix 1 to your performers.
Microphones
press HI-Z
button
Keyboards
Drum
Machine
Passive Speakers
House System
(plays mono main mix)
C300z Passive Stage Monitors
(plays mon 1 output)
Po wer
Amplifier
dual-mono
mode
Rear Panel
Front Panel
Po wer Amp Mode
switch set to
Mains/Mon 1
Adjust
Vo cal
Compression
SRM150 Po wered Monitor
(plays mon 1 output)
Passive Subwoofers
(plays main mix below 100 Hz)
Acoustic Guitar
and Mic