Filter
Top Products
9
Owner’s Manual
Owner’s Manual
Large Band System
This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars con-
nected directly to ch. 5 and 6 (with hi-z switches pressed in), a guitar processor connected to ch.6 insert,
a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel 8. Add
vocal compression as required, by tweaking the compression knobs on channels 1 to 4.
The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on
channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play.
Mackie HD1531 powered speakers and powered subwoofers are connected to the line-level main mix
outputs, and play the stereo main mix to your audience.
C200z passive stage monitors are connected to the channel B speaker-level power output of the pow-
ered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors are
connected to the channel A speaker-level power output, and play stage monitor mix 1.
Microphones
press HI-Z
buttons
Guitar Processor
(connected to INSERT)
Send
Return
Keyboards
C300z Passive Stage Monitors
(plays mon 1 output)
HD1531
Po wered
Speaker
HD1531
Po wered
Speaker
C200z Passive Stage Monitors
(plays mon 2 output)
Rear Panel
Front Panel
Po wer Amp Mode
switch set to
Mon 1/Mon 2
Adjust
Vo cal
Compression
Electronic Drum Kit
Po wered Subwoofer
(plays left main mix)
Po wered Subwoofer
(plays right main mix)