Filter
Top Products
AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11) — PAGE 21
AR13D RIDE-ON ROLLER — ENGINE COMPONENTS
Operating the engine without an air filter,
with a damaged air filter, or a filter in need of
replacement will allow dirt to enter the
engine, causing rapid engine wear.
INITIAL SERVICING
The engine (Figure 6) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the manufacturer's engine
manual for instructions & details of operation and servicing.
1. Thermostat – Regulates the temperature of the engine
coolant.
2. Oil Filler Cap – Remove to add engine oil.
3. Starter – Starts engine when ignition key is rotated to the
"ON" position
4. Oil Pan– Holds a maximum of 3.5 quarts (3.3 liters) of
motor oil.
5. Alternator– Provides charge for battery and voltage for
the +12 VDC electrical system.
6. Injection Nozzle – Injects diesel fuel into the cylinder.
7. Glow Plugs – Heating element used for starting the engine
in cold weather conditions.
8. Oil Drain Plugs – Remove to drain crankcase oil. Fill with
recommended type oil as listed in Table 4.
9. Oil Filter – Spin-on type, filters oil contaminants.
10. Oil Dip Stick – Remove to check amount and condition of
oil in crankcase. Refill or replace with recommended type
oil as listed in Table 4.
12. Injector Pump– Provides fuel under pressure to the
injector nozzles.
14. Air Filter – Prevents dirt and other debris from entering the
fuel system. Unsnap air filter cover to gain access to filter
element.
Engine components can generate extreme heat.
To prevent burns, DO NOT touch these areas
while the engine is running or immediately after
operating. NEVER operate the engine with the
muffler removed.
WARNING - BURN HAZARD
Figure 6. B&S 850D Diesel Engine Controls and Components