Filter
Top Products
PAGE 22 — AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11)
AR13D RIDE-ON ROLLER — INSPECTION
Before Starting
1. Read safety instructions at begining of manual.
2. Clean the
ROLLER
, removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with dry
compressed air.
5. Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the roller on secure level
ground with the engine stopped.
2. Remove the dipstick from its holder (Figure 7) and wipe it
clean.
3. Check the oil level shown on the dipstick (Figure 8).
Figure 7. Engine Oil Dipstick (Removal)
To assure proper venting, always remove the
dipstick when adding oil. ALWAYS be sure to
check the engine oil level prior to starting the
engine.
Figure 8. Engine Oil Dipstick
4. If the oil level is low, remove the oil filler cap (Figure 9) and
fill to the safe operating level (F) as indicated by the dipstick.
Pour oil slowly. Fill with recommended type oil as listed in
Table 4. Maximum oil capacity is 3.5 quarts (3.3 liters).
Figure 9. Engine Oil Filler Port
edarGliOrotoM.4elbaT
erutarepmeTronosaeS
liorotomfoedarG
)ssalcSMnahtrehgih(
nmutuAroremmuS,gnirpS
F°51+otF°021+
03EAS
retniW
F°5
1+otF°04+
03EAS
F°51+woleB03-W01EAS