Filter
Top Products
PAGE 14 — MULTIQUIP EM-900SDCE — OPERATION AND PARTS MANUAL — REV. #2 (09/14/07)
1. Engine Cover — Lift this cover to gain access to the engine
compartment.
2. Clutch Engagement Lever — Push the clutch lever
forward, toward the tow end of the mixer to engage clutch.
Once the clutch is engaged the paddle shaft will begin to
rotate. To disengage clutch pull the clutch backwards
towards the engine.
3. Throttle Control/Stop Switch — Pull all the way out to
achieved maximum engine RPM's. To stop the engine, push
the RED stop button inwards.
4. Safety Grill — Provided for operator safety. This safety grill
is designed to keep hands and solid objects out of the
mixing drum when in use. This grill should be closed at all
times when mixer is in use. DO NOT remove the grill or grill
opening bar. Keep the grill clean by washing it down daily.
5. Bag Cutter— This feature allows compound mixing bags
to be opened easily, therefore allowing the contents of the
bag to fall directly into the mixing drum.
6. Dump Handle — Pull this handle downward to dump the
contents of the drum. Push the handle upward to return the
drum to its vertical position.
7. Transport Handle — Use this T-handle to transport the
mixer. NEVER tow this mixer on a highway.
8. Pivot Point/Zerk Fitting — There is, on each end of the
mixing drum a zerk grease fitting. These fittings lubricate
the dumping mechanism. Lubricate both fittings at least
twice a week.
EM-900SDCE MIXER — CONTROLS AND COMPONENTS
9. Dump Handle Release Pin — Pull this pin outward (spring
loaded) to release the drum, then pull down on the dump
handle to place the drum in the dump position. When drum
is in dump position, pin will automatically lock drum.
10. Tires — This unit employes the use of soild rubber tires.
11. Transport Bar Release Latch — To transport the mixer
un-hook the transport bar from the latch. When work is
being performed ALWAYS have the transport bar latched
in the upright position.
12. Safety Grill Lock Handle — To prevent injury to hands
and arms, the safety grill should ALWAYS be locked when
the mixing of plaster or mortar is required. Also when
transporting the mixer the safety grill should be locked. The
safety grill should only be un-locked when cleaning of the
blades and drum is required.
13. Steel Mixing Drum — Mixing materials such as concrete,
mortar, plaster are to be placed into this drum for mixing.
Always clean the drum after each use.
14. Mixing Paddles — Used in the mixing of material. This
unit uses four different types of paddles to provide a fast
uniform mix.
15. Bunjee Latch — Use this latch to secure the engine
compartment cabinet.
16. Fork Lift Pocket — When lifting of the mixer is required,
use these fork lift pockets to lift the mixer. Remember to
insert the forks of the fork lift a minimum of 60.96 cm. (24
inches) into the mixer's fork lift pocket.
Figure 2. Mixer Major Components