5
Once you have connected the VirtualVinyl box to your computer and connected the box to your
turntables/CD players and mixer as shown in the Hookup Diagram, please install and run the
VirtualVinyl software.
Before you can begin playing, you will need to configure the software’s timecode settings. You
can access these settings by clicking on the CONFIG button at the top right of the VirtualVinyl
software window. This will take you to the VirtualVinyl Settings menu. Please select the Sound
Setup tab.
You will see the screen displayed on the right:
1. Under Inputs, select Timecodes if you
are using two turntable or CD players.
(You can also mix with only one turntable
or CD player. Please see DJing With One
Turntable/CD Player section for more
information)
2. Under Outputs, select External Mixer.
(If you do not have a mixer, you may
choose to use the internal mixer by
selecting the Single Output option. If you
have a 3-channel mixer, you may wish to
use the 3-Lines Mixer option – this will
allow you to trigger samples on the third
output channel. If you would like to take
advantage of this feature, please connect
the Output 3 of the VirtualVinyl box to the
third channel of your mixer).
3. Under Sound Card(s) you will see VirtualVinyl selected automatically. If it is not selected,
please select it from the pull-down menu.
4. Under Input Channels, you can decide which deck each set of inputs is controlling. We
recommend leaving them as they are.
5. Under Output Channels, you can decide which outputs of the VirtualVinyl box each deck
will use.
6. Lastly, you will need to configure the timecode setting by pressing the TIMECODE
CONFIG button. Please see the following section for details on timecode configuration.
CONFIGURING THE VIRTUALVINYL SOFTWARE