Filter
Top Products
23
to turn it off when they are finished. If more than one speaking mic is in use, turn the mics on and let the Automix
™
do the work.
Inputs 1–4 are automatic mix channels intended for spoken word. The S-24
™
will take care of most of the mixing for
these channels but if someone is difficult to hear or just too loud, you may need to adjust the level of their mic.
If you have different soloists or small groups of singers or instruments, you will likely need to set the mics to meet
their unique requirements.
a. Begin by setting the fader at 0 and adjusting the channel GAIN for proper level.
b. Adjust the equalization for clear natural sound. Don’t boost the equalization if you can make it sound better
by cutting. (Turn down the bass or mid-morph first) boosting the mid-morph would be the next step.
c. Make sure that they can hear what they need in their monitors. Remember‚ putting too many things in the
monitors can actually make it harder to hear.
d. Use the fader to adjust as needed.
e. Adjust the Group Compressor so the LED just blinks.
Before the service or performance begins, it is a good idea to know how much adjustment range you have on the
choir and solo mics without getting feedback. Beware, if you turn up a mic and it feeds back then stops, the
Feedback Ferret
®
has just added a new filter temporary filter. Don’t mute that mic and expect to be able to achieve
that same setting later. The Ferret will release temporary filters after a while if they are not needed and the
feedback could return.
Advanced Control Setup
Many of these controls need only be adjusted once, but are best set during actual system operation.
Adjusting the Group Off-Level Controls
Lets start with an explanation of what the controls do and what we hope to accomplish with
them. The Off Level control works to automatically do what a good sound operator would
do: turn down or off microphones when they are not in use. If you plan to have an operator
do this, then the control can be left off. (Full Counter-clockwise) However‚ if the Choir or
Solo mics will be left on and you want to reduce the pickup of noise or the sound of persons
speaking as heard through the monitors, then the Auto-Off circuit can be used.
This circuit does not turn the microphones off, but turns them down. How much it turns them down depends on
the sound level through the mics and the setting of the Off Level control. The Off Level control is called a threshold
control. The circuit starts working when the volume is below the threshold set by this control. When the sound
from the mics in this group is above the threshold volume, the signal is unaffected and the Off Light goes out. If the
sound from the mics drops below the threshold, then the circuit starts turning them down and the Off light comes
on. The further the signal from the mics is below the threshold, the further they are turned down. The goal in
setting this control is to find a point where the threshold is high enough to turn down unwanted sound, but low
enough so that desired sound is unaffected. It may take some experimenting to get this set but the circuit is quite
forgiving. Once you get this set, mark the setting and leave it.
Turn Off Level
control slowly
clockwise until the
Off Light comes on.