Filter
Top Products
p.93
master HS module
talkback features
The
TALKBACK system provides facilities for assigning an external signal
(usually the console operator's microphone) to any of the console's out-
puts. Other signals can be routed through the
TALKBACK system including
an external tone oscillator or the built in
PINK NOISE generator.
talkback level
This control sets the level that appears at any of the outputs with
their respective
TALK TO switches engaged. It also governs the audio level
at the
TALKBACK output on the rear panel.
pink noise
The TALKBACK in-connector is disabled and PINK NOISE is sent though
the
TALKBACK system.
talkback on—TALK ON
This switch must be activated for the TALKBACK system to operate.
There are two-ways to activate it:
1 Momentary - Depressing the button for more-than 1/2 of a second will
cause it to act as a momentary switch.When the button is released, the
TALKBACK section will be shut-off.
2 On / Off - A quick tap on the button (less-than 1/2 second) will cause
the switch to electronically change its state from on-to-off or from off-to-on.
left/right/center—LCR TO OUTPUTS
This feature is useful for monitoring the console when creating an LCR
mix. Local monitoring is usually done with two speakers.The
LCR to out-
puts feature combines the center (or mono) signal with the left and right
signals, creating a phantom center channel.This feature affects the
ALT OUT
section,the
MONITOR OUT
section,the HEARINGASSIST output and the head-
phone feed.
Center (mono) channel is not included in the
MONITOR
paths.
The center (or mono) channel is combined with left and right
MON-
ITOR
outputs.This makes it possible to hear the center channel without a
designated speaker.
5