Filter
Top Products
44
Microphone Audio Page
The microphone audio page allows setting audio parameters for each
microphone individually. The page is structured into two areas. The top area
is set up for adjusting the input signal, and processing the signal by applying
filters, and EQ settings to the audio. The bottom of the table is focused on
output signal and an output gain stage as well as the microphone/line level
setting for the analog audio output.
Input Signal
The Input Signal area allows trimming the input signal for each microphone
separately, allowing for input levels of different microphones to be optimized
individually.
For XLR and TA4 adapters, an additional pre-gain stage is offered. The
Revolabs microphones (omni-directional, directional, gooseneck, and wearable)
are set to provide signals on the same level with a focus on providing the best
signal to noise ratio with the lowest risk of clipping of audio. XLR and TA4
adapters’ third party microphone elements are provided by the customer. The
pre-gain stage is provided to enable greater control over leveling the analog
signal of these microphones for highest signal levels without clipping. Please
ensure that signals are correctly set based on the microphone elements used
with these adapters.