Filter
Top Products
Ridge Tool Company10
Loading The Machine On Vehicle
Loading Wheel
Optional loading wheel swivels up and down. Raise
wheel for loading, lower wheel while transporting or op-
erating machine.
With loading wheel raised, tip machine backwards and
rest handle or loading wheel on truck bed. Lift up on front
of machine and slide onto truck.
Use proper lifting technique – lift with your
legs, not your back!!
NOTE! Take care not to damage electrical cord or air
foot switch hose.
Lifting Hook
Optional lifting hook can be used to raise and lower the
machine into a truck using a hoist. The Machine must be
raised by hooking through the hole in the lifting hook.
Lifting the machine by the handle or any
other part of the machine may result in the machine tipping
and/or the part failing. This could result in the machine
falling causing serious injury.
NOTE! Take care not to damage electrical cord or air foot
switch hose.
Draining the Drum
Water can be drained from the drum by removing the
screw plug located in the rear of the drum (Figure 10) and
resting the machine on its back as seen in Figure 11. Be
sure the screw drain plug is replaced before transporting
the machine.
Figure 10 – Drum Drain Hole
Operating Machine In Reclined Position
The K-6200 can be operated in the reclined position to ac-
cess overhead waste lines. As shown in Figure 11, screw
the two (2) support legs into the frame. With the kickstand
bar in the forward position ahead of the wheels, place the
machine so it rests on the support legs and the wheels.
If sewer inlet is greater than 3′ from the
front off the machine, the cable will have a greater ten-
dency to twist or kink. Use a front guide tube or properly
support exposed cable.
Figure 11 – Machine In Reclined Position
Drum Assembly Removal & Installation
WARNING
Make sure FOR/OFF/REV SWITCH is in OFF position
and machine is unplugged from power source.
Drum Removal
1. Set kickstand in the operating position to keep the ma-
chine from moving.
2. Loosen the top autofeed knob to make sure the top
bearing is not in contact with the cable and remove the
cutter.
3. Loosen the two T-handle mounting knobs located
on the drum side of the autofeed assembly. It is not
necessary to remove the knobs, just loosen enough to
allow the autofeed assembly to slide off the front
support. Slide the assembly off the cable.
4. The drum assembly can be removed by grasping
the drum via the center hole on the drum front and by
lifting and sliding the shaft of the assembly out of
the gear box.
Use proper lifting technique – lift with your
legs, not your back!!
Drum Installation
1. Set the kickstand to keep machine from moving.
2. Grasp the drum assembly via the center hole on the
drum front and lift the assembly onto the frame. Slide
K-6200 Drain Cleaning Machine
WARNING
WARNING
WARNING
WARNING