Filter
Top Products
9
23 23
USB FOR UPDATE Connector
This is used to update the VP-7’s internal program.
NOTE
For normal use, do not connect anything to this connec-
tor.
12
[POWER] Switch (p. 15)
This turns the power of the VP-7 on/o.
13
DC IN Jack (p. 10)
Connect the AC adaptor here.
14
MIDI IN Connector (p. 11)
Connect your MIDI device here.
15
FOOT PEDAL Jack (p. 14, p. 24)
Connect a foot pedal here.
This lets you use a foot pedal to control the function of the [Bypass]
button.
16
[TUNE] Knob (p. 26)
This knob adjusts the tuning.
You can adjust the tuning over a range of 438–442 Hz in 1 Hz steps.
17
[PHANTOM] Switch (p. 13)
Turn this on if you’ve connected a condenser microphone that
requires phantom power.
* Turn this o if you’re using the included microphone (DR-HS5).
* Supplying phantom power to a dynamic microphone or audio
playback device will cause malfunctions.
18
MIC IN Jack (both XLR and 1/4” phone) (p. 13)
Connect your microphone here.
The Mic input connector supports either XLR type or phone type
plugs.
The XLR type connector supports 48V phantom power, allowing you
to connect a condenser microphone that requires a phantom power
supply.
19
LINE INPUT Jack (STEREO) (p. 28)
Here you can connect your portable audio player or the audio
output of your MIDI-connected keyboard.
* The VP-7’s [Volume] knob does not aect the LINE INPUT. Use the
volume control of the connected keyboard to adjust the volume.
20
OUTPUT Jacks (p. 12)
These jacks output the VP-7’s sound in stereo (L/R).
927
21
Ground Terminal
Depending on the circumstances of a particular setup, you may
experience a discomforting sensation, or perceive that the surface
feels gritty to the touch when you touch this device, microphones
connected to it, or the metal portions of other objects, such as
guitars. This is due to an innitesimal electrical charge, which is
absolutely harmless. However, if you are concerned about this, con-
nect the ground terminal (see gure) with an external ground. When
the unit is grounded, a slight hum may occur, depending on the
particulars of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or an authorized
Roland distributor, as listed on the “Information” page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in re or explosion)
• Telephone-line ground or lightning rod (may be dangerous in
the event of lightning)
988
22
Security Slot (
)
• http://www.kensington.com/
Bottom Panel
Rear Panel
22
15 16 17 18 19 20
21
141312