Filter
Top Products
3
English
Control Map Guide
When shipped from the factory, the A-300PRO/500PRO/800PRO (referred to simply as
“the A-PRO” in the following) contains 19 control maps. By making use of these control
maps, you can easily set up the A-PRO to control your software or hardware.
(*1) Depending on the software you use, the content of a control map may be altered.
If this list does not contain a control map for the software or hardware you’re using,
check the Roland website to see whether a suitable control map might be available.
Roland website
http://www.rolandus.com/support/
If a suitable control map is available, you can download it and transmit it to the A-PRO.
Refer to “Transmitting a Control Map to the A-PRO” within “Using A-PRO Editor” in the
owner’s manual.
Here’s how to switch between control maps.
1
Choose PLAY mode (see “Performing (Play mode)” in the owner’s
manual.)
2
Press the [ ] button or [ ] button to move the cursor to “CTRL
MAP” in the display.
The display shows the number of the currently selected control map.
3
Turn the [VALUE] knob to select the desired control map number.
The supplied stickers correspond to control map number16, GM2.
As necessary, affix them in the locations shown below.
Copyright © 2010 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Control map number
Corresponding software/hardware
1 Cubase SOLO
2 Cubase MUTE
3 Cubase RECORD
4 Logic SOLO
5 Logic MUTE
6 Logic RECORD
7 Logic GLOBAL
8 Logic INITIALIZE
9 DP (Digital Performer) SOLO
10 DP MUTE
11 DP RECORD
12 Live SOLO
13 Live MUTE
14 Live RECORD
15 GarageBand
16 GM2
17 SD-50
18 Generic MIDI Controller
19 (*1) NO ASSIGN
A-PRO_g_e.book 3 ページ ２０１０年５月２６日 水曜日 午後３時４６分