Filter
Top Products
51
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign a control change message to a controller.
1 Press the [ACT] button and [ ] button simultaneously.
2 Slightly move the controller to which you want to assign a control
change message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
3 Verify that the display, and press the [ENTER] button.
fig.lcd-controlchange.eps
4 Turn the [VALUE] knob until
“CONTROL CHANGE” appears in the
display.
fig.lcd-midichannel.eps
5 Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
6 Use the [VALUE] knob to specify the desired MIDI transmit channel.
fig.lcd-ccnumber.eps
7 Press the [ENTER] button.
The display will indicate the currently
specified control change number.
8 Use the [VALUE] knob to select the desired control change number.
9 Press the [ENTER] button.
The display will indicate the currently specified control change number.
10
As appropriate for the type of controller, specify the desired “Button
mode setting” (p. 55) or “Virtual center click setting” (p. 55).
Control Change Assignment
MIDI transmit channel Control change number Port Button mode
1–16 0–127 (00–7FH) PORT1 (fixed) UNLATCH, LATCH, INCREASE
A-300_500_800C_e.book 51 ページ ２０１０年２月２２日 月曜日 午後９時１３分