Filter
Top Products
52
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign a program change message to a controller.
1 Press the [ACT] button and [ ] button simultaneously.
2 Slightly move the controller to which you want to assign a control
change message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
3 Verify that the display, and press the [ENTER] button.
fig.lcd-programchange.eps
4 Turn the [VALUE] knob until
“PROGRAM CHANGE” appears in the
display.
fig.lcd-midichannel.eps
5 Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
6 Use the [VALUE] knob to specify the desired MIDI transmit channel.
fig.lcd-pcnumber.eps
7 Press the [ENTER] button.
The display will indicate the currently
specified program change number.
8 Use the [VALUE] knob to select the desired program change
number.
9 Press the [ENTER] button.
If you’ve assigned this message to [R1]–[R9], [S1]–[S9], or EXPRESSION (P2), moving
the controller to the maximum position will transmit the program change message
you specified.
Program Change Assignment
MIDI transmit channel BANK MSB BANK LSB Program number Port
1–16 X X 0–127 (00–7FH) PORT1 (fixed)
A-300_500_800C_e.book 52 ページ ２０１０年２月２２日 月曜日 午後９時１３分