Filter
Top Products
33
Using A-PRO Editor
The setting items shown in the message assign window will depend on the MIDI message you’ve selected. This section explains the setting items for each MIDI message. Values for parameters
are specified in decimal.
For details on the Settings field, refer to “Message Assignment Window” (p. 24).
NO ASSIGN
Clears any message assignment.
No message will be sent even if you operate a
controller that’s set to NO ASSIGN.
fig.editor-noassign.eps
There are no parameters to set.
* If HOLD, EXPRESSION, BENDER, MODULATION, or
AFTERTOUCH settings are set to NO ASSIGN, the
corresponding controller will control its own original
function. In this case, the current channel will be
used as the MIDI transmit channel.
Channel Message
Assigns a channel message.
Use the Type field to select the type of message you
want to assign. According to the message you’ve
selected, set the following parameters.
Note
Assign a note message.
fig.editor-note.eps
Specify the following parameters.
Channel Pressure
Assign a channel pressure message.
fig.editor-chpress.eps
Specify the following parameters.
Message Parameters
Item Content
MIDI Channel MIDI channel
Note Number Note number
Velocity Velocity
Item Content
MIDI Channel MIDI channel
Min Value Lower value of channel pressure
Max Value Upper value of channel pressure
A-300_500_800C_e.book 33 ページ ２０１０年２月２２日 月曜日 午後９時１３分