Roland CUBE 80XL Musical Instrument Amplifier User Manual


 
10
Using a Latch-type Foot Switch
The CUBE-40XL/CUBE-80XL also support latch-type foot switches. If
you’re using a latch-type foot switch, make the following settings.
FOOT SW TYPE setting
There are two types of foot switches.
Type Operation
Momentary type
(BOSS FS-5U, etc)
This type remains on (or o ) while depressed
and switches o (or on) when released.
Latch type
(BOSS FS-5L, etc.)
This type switches on or o each time it is
depressed.
* The BOSS FS-6 can operate as either a momentary or latch-type
pedal switch.
CUBE-40XL
At the factory settings, the momentary type is selected. You can
change this setting as follows.
To specify the latch type
Turn on the power while holding down the [TAP/STOP] switch.
To specify the momentary type
Turn on the power while holding down the [REC/PLAY/DUB] switch.
CUBE-80XL
Set the [FOOT SW TYPE] switch on the rear panel
to FS-5L (LATCH).
* The setting you specify is remembered even
while the power is turned off .
Foot Switch Settings
(RING)
(TIP)
Polarity switch
BOSS FS-5L
REVERB
SOLO
EFX
CH SELECT
EFX
CH SELECT
REVERB
SOLO
B A
Set the switches as shown as bellow.
BOSS FS-6
(RING)
(TIP)
Polarity switch
BOSS FS-5L+FS-5U
DELAY/
REC/PLAY/DUB
TAP/STOP
DELAY/
REC/PLAY/DUB
TAP/STOP
B A
Set the switches as shown as bellow.
BOSS FS-6
* Even if FOOT SW TYPE is set to FS-5L (LATCH), you must always use
a momentary-type foot switch for TAP/STOP. This function will not
work correctly with a latch-type foot switch.
Important Notes When Using a Latch-type Footswitch Pedal
The on/o state of the footswitch pedal takes precedence over the
control panel for switching EFX, delay, or reverb on and o .
However, the on or o states of EFX, delay, or reverb stored in memory
using the SOLO function take precedence when saved SOLO-function
panel settings are called up. Such cases may result in con icting
indicator displays on the control panel and the footswitch pedal, but
this is not a malfunction.
Convenient Applications
You can use either of the following settings to control operation when
the panel settings for EFX, delay, and reverb are called up using the
SOLO function.
Foot switch priority mode
Make the on/o state of the footswitch pedal always take priority.
To make the setting:
Hold down the [SELECT] switch and switch on the power.
Memory priority mode (factory setting)
Make the on/o state saved using the SOLO function take priority.
To make the setting:
Hold down the [TUNER] switch and switch on the power.
* The changed setting remains in memory after the power is switched
off .