Roland CUBE 80XL Musical Instrument Amplifier User Manual


 
12
You can save and call up the panel settings (those enclosed by the line
in the  gure) for sounds you create. On this unit, this function is called
“SOLO.” This is a convenient way to switch between a backing sound
and a solo sound.
You can save one setting each for the JC CLEAN channel and for the
LEAD channel. You can switch between a total of four sounds.
With the factory settings, the sample setting “Space Clean” is saved for
the JC CLEAN channel, and the “Extreme” setting (p. 16) is saved for the
LEAD channel.
CUBE-40XL
JC CLEAN
LEAD
CUBE-80XL
JC-CLEAN
LEAD
Saving the Panel Settings
1. Set the SOLO [VOLUME] knob to 0.
NOTE
If the SOLO volume is set high, the
sound may be unexpectedly loud
when the panel settings are saved.
Before saving, lower the volume to 0.
2. Create a sound.
3. Press and hold the SOLO [ON/OFF switch] on the panel for
several seconds.
The indicator will blink. When the panel settings
have been saved, the indicator will change from
blinking to lit.
* Never switch off the power while the indicator
is blinking.
4. Use the SOLO [VOLUME] knob to adjust
the volume.
* Saved panel settings remain in memory even after the power is
turned off .
Recalling the Saved Sound
1. With SOLO off , press the SOLO [ON/OFF] switch.
The SOLO indicator will light, and the saved panel settings will be
recalled. The sound you created and saved for JC CLEAN will be
recalled if the JC CLEAN channel is selected, and the sound you created
and saved for LEAD will be recalled if the LEAD channel is selected.
* If panel settings have not been saved, or if you’re using the CUBE for
the  rst time, the factory settings will be recalled.
Editing the saved settings
1. Press the SOLO [ON/OFF] switch to call up the saved settings.
2. Turn the panel knob for the item you want to change, and
modify the setting.
The SOLO indicator goes out brie y when the position of the knob
coincides with the position stored in memory.
3. Hold down the SOLO [ON/OFF] switch for several seconds.
The indicator will blink. When the panel settings have been saved, the
indicator will change from blinking to lit.
* Never switch off the power while the indicator is blinking.
* Once the new settings have been saved, the previous settings in
eff ect before the changes cannot be called up again.
* To quit without saving the changes, press the SOLO [ON/OFF]switch
or the [SELECT] switch.
Using the SOLO Function