Filter
Top Products
78
Various Settings
In some cases, when USB memory is connected to the external
memory connector, it may take longer for data to be loaded,
or data may fail to be loaded successfully. If this occurs, you
may be able to solve the problem by changing the external
memory setting.
1.
Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2.
Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“UMd.”
When you take your finger off the button, the display
will indicate the value of the setting.
3.
Use the [-] [+] buttons to change the setting.
4.
Turn on the power once again.
This setting is remembered even when the power is
turned off.
If you are playing the DP-990 through a connected external
system, there may be cases in which the volume from your
external system is too low even when the DP-990’s volume is
turned to the maximum setting. In such cases, you can adjust
the master gain setting as follows.
Adjusting the master gain will also affect the volume of the
internal speakers and headphones.
The sound may distort if you increase the volume
excessively.
1.
Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2.
Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“MAS.”
When you take your finger off the button, the display
will indicate the value of the setting.
3.
Use the [-] [+] buttons to change the setting.
Changing the External Memory Setting
(External Memory Mode)
Setting
Explanation
Mode 1
Mode 2
Adjusting the Volume (Master Gain)
Setting
-10–0–10 dB
NOTE
DP-990_e.book 78 ページ ２００７年８月２２日 水曜日 午後４時３５分