Filter
Top Products
43
Chapter 4 Other Functions
Changing How the Pedal
Effects Are Applied
When the pedal is pressed in Dual Play (p. 18) or Split Play
(p. 19), the pedal’s effect is applied to both the Upper Tone
and the Lower Tone, but you can change the settings for the
tone to which the effect is applied.
■
How the Soft Pedal(FC2)
effects are applied
1.
Switch to Function mode, and press the [E.Piano]
button.
fig.04-03
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
■
How the Sostenuto Pedal(FC1)
effects are applied
1.
Switch to Function mode, and press the [Organ]
button.
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
■
How the Damper Pedal effects
are applied
1.
Switch to Function mode, then press the [Guitar/
Bass] button.
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
Changing How the Pedals
Work
A pedal connected to the Soft(FC2) jack normally functions as
a soft pedal (p. 9). A pedal connected to the Sostenuto(FC1)
jack normally functions as a sostenuto pedal (p. 9).
It can also be set to function as an another works.
You can select from the following ten pedal functions.
*
With certain sounds, the function may not work.
* What is the leading bass function?
The function that sounds the lowest note of a fingered chord
as the bass tone is called “Leading Bass.”
* Use only the specified expression pedal (EV-5; sold separately).
By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
* The function may not work properly if a pedal other than the
supplied pedal or expression pedal is used.
* Be sure to switch off the power to the unit before attempting to
disconnect or connect a pedal cord.
Indication Description
U-L
All enabled
-U-
Applied only to the Upper Tone
-L-
Applied only to the Lower Tone
flashes in red
Indication Description
dnP
(Damper)
Sets function to damper pedal.
SFt
(Soft)
Sets function to soft pedal.
Stn
(Sostenuto)
Sets function to sostenuto pedal.
EPr
(Expression)
Allows control of the volume. Connect a
separately available expression pedal
(EV-5).
* You cannot change volume level of session
partner.
r.St
(Start/Stop)
Allows control the start/stop of Session
Partner by pressing the pedal, instead of
pressing the buttons.
L.bS
(Leading bass)
Allows control the on/off of leading bass
function*. It is turned on while having
stepped on the pedal.
EFF
(On/Off of
Effects)
Effects can be switched on/off by pressing
the pedal instead of pressing the [Effects]
button.
When effect type is rotary, you can control
the slow/fast of spinning.
b.uP
(Bend Up)
Pitch rises by pressing the pedal
b.dn
(Bend Down)
Pitch lowers by pressing the pedal
Mod
(Modulation)
Vivrato is added by pressing the pedal
FP-5_e.book 43 ページ ２００５年１月２６日 水曜日 午前１０時２２分