Filter
Top Products
10
PD-80R/PD-80 (V-Pad)
Before using the PD-80R and the PD-80, you need to adjust the
head tension (p. 6).
fig.P01.j
Attaching the Pad to a Stand
Attach the PD-80R or PD-80 to a stand (MDS series).
fig.P02.j
When attaching the PD-80R and the PD-80 to the pad mount,
be sure to tighten the stand fixing screw securely. If any of
them remain loose, the pad could fall off.
Adjustment for Positional Sensing
with the TD-8
When the TD-8 is used as the sound module, the location at which
the pad is struck can be varied to produce tonal changes. In this
case, it is important to adjust the head so the tension is evenly
distributed, so the striking location can be detected accurately.
For details on adjustments, refer to the TD-8 owner's manual.
The positional sensing function works only with TD-8’s
trigger input 3 (SNARE).
Specifications
PD-80R: V-Pad
Pad Size: 8 inches
Trigger: 2 (Head, Rim)
Dimensions: 245 (W) x 310 (D) x 95 (H) mm
9-11/16 (W) x 12-1/4 (D) x 3-3/4 (H) inches
Weight: 1.7 kg
3 lbs 11 oz
PD-80: V-Pad
Pad Size: 8 inches
Trigger: 1 (Head)
Dimensions: 245 (W) x 310 (D) x 95 (H) mm
9-11/16 (W) x 12-1/4 (D) x 3-3/4 (H) inches
Weight: 1.6 kg
3 lbs 8 oz
CY-12R/C (V-Cymbal)
Attaching the V-Cymbal to the
Cymbal Mount
Attach the CY-12R/C to the cymbal mount of a drum stand
(MDS series).
1.
Use the included tuning key to tighten the stopper bolt.
The stopper keeps the CY-12R/C from turning, and
Hoop (Rim)
Tuning Bolt
Washer
Sensor
Stand
Fixing Screw
Head
Holder
Frame
Output Jack
Rod
Pass the rod through the pipe
that is inside the holder.
Tighten
Loosen
Bell
Bow
Edge
BOW/BELL
Output Jack
BOW/EDGE
Output Jack
PD-80R/PD-80 (V-Pad) / CY-12R/C (V-Cymbal)