Filter
Top Products
13
FD-6
(Hi-Hat Control Pedal)
• The tips of the anchor bolts are sharp. Handle with care.
• When using on flooring, the anchor bolts may damage
the floor. Do not attach the anchor bolts.
• When the FD-6 is not going to be used for a long period
of time, move and fix the arm, allowing longer travel for
the pedal.
• To avoid damage, do not leave the FD-6 for extended
periods of time with the pedal plate depressed.
The TD-8 owner's manual assumes use of the FD-7 Hi-Hat
Control Pedal. For each instance in which you find “FD-7”
mentioned in the TD-8 owner's manual, please substitute the
name “FD-6.”
Specifications
FD-6: Hi-Hat Control Pedal
Dimensions: 160 (W) x 395 (D) x 120 (H) mm
6-5/16 (W) x 15-9/16 (D) x 4-3/4 (H) inches
Weight: 1.4 kg
3 lbs 2 oz (including anchor bolts)
TD-8
(Percussion Sound Module)
Attach the stand holder (included with the drum stand) to the
TD-8.
fig.TD01.e
• To attach the stand holder, remove the four 12 mm
screws (M5 x 12) from the bottom of the TD-8 and use
them. Use of other screws may result in damage to the
unit.
• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
Adjusting the Travel of the Pedal
Loosen the bolt with the included tuning
key. After adjusting, tighten the bolt.
Shift the Arm
deep
shallow
Control Out Jack
Pedal Plate
Attaching the Anchor Bolts
(When Using on the Carpet)
Anchor Bolt
Spring for
the Anchor Bolt
Wide
Narrow
FD-6 (Hi-Hat Control Pedal)/TD-8 (Percussion Sound Module)