Filter
Top Products
22
Connecting to Audio Equipment
Read this chapter if you wish to connect the F-50 to an audio
device.
By connecting the F-50 with an audio device, you can listen
to the sound of the F-50 through the speakers of the audio
device, or record your performance onto a cassette tape or
other recording media.
About the Jacks
fig.8-01
Output Jacks
Use audio cables (sold separately) to connect the F-50 to an
audio device so that the sound of the F-50 can be hear from
the speakers of the audio device, or so that your performance
can be recorded on a cassette tape or other recording media.
Input Jacks
You can use audio cables (sold separately) to connect another
audio producing device to the F-50, and hear its sound
through the speakers of the F-50.
Making the Connections
NOTE
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
1.
Turn the volume down completely on all
equipment.
2.
Turn off the F-50 and any other devices to be
connected.
3.
Use audio cables (sold separately) to connect the
other device to the F-50.
NOTE
If the device you are connecting is monaural, connect it to the
L (Mono) jack. In this case, do not connect the R jack of the
F-50.
NOTE
Use a cable from Roland to make the connection. If using
some other make of connection cable, please note the
following precautions.
Some connection cables contain resistors. Do not use cables
that incorporate resistors for connecting to this unit. The use
of such cables can cause the sound level to be extremely low,
or impossible to hear. For information on cable specifications,
contact the manufacturer of the cable.
NOTE
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
■
Listening to the F-50 through the
speakers of an audio device, or
recording a performance onto a
cassette tape or other media
fig.8-02
1.
Turn on the power to the F-50.
2.
Turn on the power to the connected equipment.
3.
Adjust the volume.
Recording procedure
1.
Start recording on the connected audio device.
2.
Begin playing on the F-50.
3.
When you finish playing, stop recording with the
connected audio device.
■
Listening to the sound of an audio
device through the speakers of the
F-50
fig.8-03
1.
Turn on the power to the connected equipment.
2.
Turn on the power to the F-50.
3.
Adjust the volume.
NOTE
If the volume of any device connected to the Input jacks is
raised too high, you not only risk causing damage to your
hearing, you could also damage the unit’s speakers. It’s best
to always keep the sound within reasonable levels of volume.
F-50
Input R/L
(Line In, Aux In)
F-50
Output R/L
(Line Out)
F-50_e.book 22 ページ ２００５年２月２日 水曜日 午後５時１１分