Filter
Top Products
27
Troubleshooting
The pedals are
not functioning
Are the pedals connected properly?
(p. 11)
The pedals
function
intermittently
Unplugging a pedal cord from the unit
while the power is on may cause the
pedal’s effect to be applied without
stopping. The power of the F-50 must be
turned off before inserting or removing
a pedal cord (p. 11).
[Reverb]
button’s
indicator lights
automatically
Reverb is switched on automatically
whenever a demo song is played.
Since each song has been supplied with
its own reverb settings, the way in
which reverb is applied changes when
you switch demo songs.
When the F-50 is connected to an external device
No sound is
produced
Is the power to all equipment turned
on?
Are the connections between F-50 and
the MIDI sequencer or the other
external devices correct? (p. 22, p. 23)
Is the MIDI channel setting correct? (p.
25)
Is the Omni On/Off setting correct? (p.
24)
Strange
sounds (or two
sounds) are
produced when
the
F-50 is played
With the sequencer’s “Thru” function
on, the same notes may be sounded
twice. Set the F-50 to Local off (p. 24).
The volume
level of the
instrument
connected to
the Input jack is
too low
Could you be using a connection cable
that contains a resistor?
Use a connection cable that does not
contain a resistor.
Case
Cause/Remedy
F-50_e.book 27 ページ ２００５年２月２日 水曜日 午後５時１１分