Filter
Top Products
Selecting Easy or Full mode
V-Accordion
r
19
Selecting Easy or Full mode
At first, the FR-7/FR-5 is configured to start up in “Easy”
mode. In that mode, only the main parameters can be
selected. It has the advantage that you do not feel
overwhelmed by the FR-7/FR-5’s possibilities. The
downside, however, is that there are certain (albeit
rather specialized) parameters you cannot even select.
To use the full potential of your FR-7/FR-5, you need to
select “Full” mode:
(1) Switch on the FR-7/FR-5.
See “Switching the power on and off” on p. 16. The
display now looks more or less as follows:
Let us agree to call this page the “Main page”.
(2) Press and hold the [EXIT÷JUMP] button until the
display looks as follows:
(3) Press registers [10] and [2] to jump to the following
page:
(4) Press the [DATA÷ENTER] knob.
(5) Rotate the [DATA÷ENTER] knob or press the [UP]/
[DOWN] buttons to select either “Full” (show all
parameters) or “Easy” (show only the main param-
eters).
(6) Press [EXIT÷JUMP] to return to the main page.
This setting is remembered until you switch off the
FR-7/FR-5. If you want to keep it, proceed as follows:
(7) Press and hold the [MENU÷WRITE] button until the
following page appears:
(8) Rotate the [DATA÷ENTER] knob (or use the [UP]/
[DOWN] buttons) to select “Global”.
(9) Press the [DATA÷ENTER] knob to confirm your
selection.
Note: The GLOBAL page shows all parameters that are saved to
the Global memory (there is only one such memory).
(10) Press the [MENU÷WRITE] button to save your
changes. The display briefly shows a confirmation:
Note: If you don’t save the edited Global settings, they will be
used until you switch off the FR-7/FR-5 (or change the settings
again).
(11) Press the [EXIT÷JUMP] button to return to the Main
page.