Filter
Top Products
Setting up | Using the orchestral sounds
30
r
FR-7/FR-5 V-Accordion
(2) Simultaneously press the three registers in the
moddle.
The display now briefly responds with:
(3) Use the Bass registers to select the desired sound.
Note: The dynamics of sounds marked with an asterisk (*) can
only be controlled by bellows movements. Those sounds are
not velocity sensitive.
Note: The numbers shown in the illustration above do not
appear on the registers themselves. They have been added for
your reference.
■Setting the volume of the ORCH FREE BS sound
There may be times when the orchestral Free Bass
sound is too loud or too soft with respect to the Tre-
ble accordion and/or orchestral sound. In that case,
you can change its volume:
(4) Press the [DOWN] button four times.
The display now responds with:
(5) Use the [DATA÷ENTER] knob to set the desired
value.
This is actually a balance parameter with a setting
range of “Off”, –40~“Std”~+40. “Std” means that the
Orchestra Free Bass part uses its “normal” volume.
Negative values (–) make the Orchestra Free Bass part
softer, while positive values (+) make it louder.
You can save the new value (and the remaining
changes you make). See page 92.
(6) Return to the Main page by pressing [EXIT÷JUMP].
■Switching off the ORCH FREE BS part
(7) Press the three central registers again to return to
the normal Free Bass mode.
(Press them yet again to leave Free Bass mode and
return to Bass mode.)
ORCH FREE BS sounds
1* Trombone 5* Perc Organ
2* Clarinet 6 Ac Guitar
3* Oboe 7 Ac Piano
4* Flute
FREE BASS
ORCH BASS
[7] [6] [5] [4] [3] [2] [1]