Roland FR-3 Electronic Keyboard User Manual


 
Transposing the Orchestra section in octave steps
V-Accordion
r
35
Transposing the Orchestra section in octave steps
You can also transpose the Orchestra section (i.e. the
currently selected orchestral sound) up or down. This
can be interesting when you are using the Orchestra
part in Dual mode (page 25) and want it to sound
above or below the selected Treble accordion register.
Here is how to transpose the Orchestra section (i.e. the
selected PCM sound).
(1) Switch on the Orchestra section.
See “Orchestral sounds for the Treble section” on
p. 25 and following for details. Registers [1]~[0] are
now assigned to the 10 available orchestral sounds.
(2) Hold down [SET] while using register [1÷–] or [2÷+] to
select the desired setting:
Note: If the display now shows another message, briefly press
[SET] again, then repeat this step.
(3) Release the [SET] register and start playing.
Musette Detune
You probably know that an accordion’s 8’ Treble regis-
ter may consist of 2 or even 3 reeds that are usually
tuned apart to provide a richer sound (accordionists call
it the “musette effect”). One reed is tuned slightly
above, the other slightly below the correct pitch (and
the third, if available, is tuned “properly”).
Tuning those reeds is a specialist job and usually not
performed by accordion players themselves.
On the FR-3, however, “tuning” the “reeds” (that do not
really exist) is a matter of pressing a few buttons.
(1) Press and hold the [SET] register until the display
shows a parameter name, then release it.
(2) Use register [3÷√] or [4÷®] to select the following
parameter:
(3) Use register [1÷–] or [2÷+] to set the desired value.
The possibilities are: “Off” (no detune), “1” (Dry),
“2” (Classic), “3” (F-Folk), “4” (American L),
“5” (American_H), “6” (North Eur), “7” (German L),
“8” (D-Folk L), “9” (Italian L), “10” (German H),
“11” (Alpine), “12” (Italian H), “13” (D-Folk H),
“14” (French), “15” (Scottish).
They refer to commonly used detune settings.
(4) Press the [SET] register to leave “PARAM LIST”
mode.
Note: This parameter is reset when you select a different Set.
dn Transposes the Orchestra section one octave
down.
--- No transposition of the Orchestra section.
Up Transposes the Orchestra section one octave
up.
BASS
ORCHESTRA
FREE
BS
CHORD/
TREBLE
---
BASS
ORCHESTRA
FREE
BS
CHORD/
TREBLE
det
BASS
ORCHESTRA
FREE
BS
CHORD/
TREBLE
5