Filter
Top Products
15
Attaching the GK-3 to the Guitar
■ Attaching with the Holder
1. Remove three screws from the
underside of the controller, then attach
the GK-3 to holder “A.”
fig.1120e (Attaching to the Holder)
2. Loosen the guitar’s end pin, and insert
holder “A.”
fig.1130 (Attaching to the Guitar 1)
3. Screw in the end pin.
4. Attach holder “B” so that the guitar
body is sandwiched between the two
holders.
fig.1140e (Attaching to the Guitar 2)
5. Tighten holders “A” and “B” using the
flat washer, the spring washer, and the
cap nut.
* When attaching the GK-3 to an arched top guitar,
place the cushion between the guitar and holder
“A.”
fig.1150 (Spacer LP)
GK-3
Holder A
Holder B
Flat Washer
Spring Washer
Cap Nut
Holder B
Holder A
Cushion
GK-3
Cap Nut
Guitar Body