Filter
Top Products
56
Various Settings
You can adjust the volume balance between the two tones (tone 1
and tone 2) used for Dual Play.
If you are playing the HP307 through a connected external system,
there may be cases in which the volume from your external system
is too low even when the HP307’s volume is turned to the maximum
setting.
In such cases, you can adjust the master gain setting as follows.
Adjusting the master gain will also affect the volume of the internal
speakers and headphones.
* The sound may distort if you increase the volume excessively.
If desired, you can specify that the sound of a track will play at a
reduced volume rather than going completely silent when you
press a track button and turn off its indicator.
This setting lets you play a specific part at a reduced volume and use
it as a “guide” for your playing.
When you turn off the power, the track mute volume will be reset to
“0.”
Ordinarily, when playing back SMF music files for Roland Piano
Digital instruments (p. 80), the left-hand part is assigned to the [Left]
button, and the right-hand part is assigned to the [Right] button.
However, right-hand and left-hand part assignments in certain SMF
music files may differ.
If these are set to “Auto,” and as a result you are unable to use the
track buttons to control the left- and right-hand parts properly,
change the setting to “2/1 Part” or “3/4 Part.”
* This setting can be used for SMF format songs other than the
internal preset songs. It will not affect internal preset songs.
After changing this setting, try selecting the song once again.
Volume Settings
Adjusting the Dual Play Volume Balance
(Dual Balance)
Setting
9-1 (tone 1 is louder)–9-9 (same volume)–1-9 (tone 2 is louder)
Adjusting the Volume (Master Gain)
Setting
-12–0–12 dB
Using the Sound of a Specific Part as a
“Guide” (Mute Volume)
Setting
Description
0–10
Increasing the value will make the sound louder.
Changing the Parts Assigned to the Track
Buttons During SMF Playback (Track Assign)
Setting
Description
Auto
The part assigned to each track will be determined
automatically, depending on the song file.
2/1 Part
Assigns Part 1 to the [Right] button, Part 2 to the [Left]
button, and the remaining parts to the [Accomp] button.
3/4 Part
Assigns Part 4 to the [Right] button, Part 3 to the [Left]
button, and the remaining parts to the [Accomp] button.
HP307_e1.book 56 ページ ２０１０年１月４日 月曜日 午後５時３９分