Filter
Top Products
69
Connecting to Other Devices
The following become possible once you connect a USB cable
(available separately) between the USB connector on the HP307’s
left end of the bottom panel and the USB connector of your
computer.
• You can use the HP307 to play sounds from SMF music files played
back with MIDI software.
• By exchanging MIDI data with sequencer software, you can save
songs recorded with the HP307 to your computer, and enjoy a
variety of musical control and editing features.
fig.aaa
* Connect the HP307 to your computer as shown right.
Normally, you don’t need to install a driver in order to connect the
HP307 to your computer. However, if some problem occurs, or if the
performance is poor, using the Roland original driver may solve the
problem.
Specify the USB driver you want to use, and then install the driver.
1.
Enter Function mode, choose “USB Driver,” and press the
[ ] button (p. 53).
2.
Press the [-] or [+] button to switch “Generic” or
“Original.”
If you change this setting, turn on the power once again.
This setting is remembered even when the power is turned off.
For details on downloading and installing the Roland original
driver, refer to the Roland website.
Connecting a Computer
USB connector
USB connector
USB cable
Computer
Changing the USB Driver Settings
(USB Driver)
Setting
Description
Generic
Choose this if you want to use the standard USB driver that
was included with your computer.
Normally, you should use this mode.
Original
Choose this if you want to use a USB driver downloaded
from the Roland website.
Roland website
Here you can download the original driver, and view the
installation procedure and operating requirements.
Roland website: http://www.roland.com/
HP307_e1.book 69 ページ ２０１０年１月４日 月曜日 午後５時３９分