Filter
Top Products
10
Before You Start Playing
Connect the Pedal Cable
Insert the pedal cable into the Pedal connector on the
rear panel of the HP-7/3.
fig.00-01
Connect the Speaker Cable
(HP-7)
As shown in the diagram, connect the speaker cable
leading from the speaker box of the stand to the
speaker connector located on the rear panel of the HP-7.
Push the speaker cable in until it clicks into position.
NOTE
Do not place containers holding liquids (such as flower vases),
insecticide, perfume, alcohol, or similar substances on top of
this piano.
The speakers of this piano are mounted beneath the upper
surface, and face upwards. Malfunctions or accidents may occur
if liquids contact any part of the speakers.
Connect the Power Cord
Insert the included power cable into the AC inlet on the
bottom panel of the HP-7/3, and then plug it into an
electrical outlet.
NOTE
Be sure to use the supplied power cord.
fig.00-02
Setting Up the Music Stand
(HP-3)
Insert the music stand into the two holes as shown in
the following diagram.
fig.00-03
NOTE
Before moving the piano, be sure to remove the music stand to
prevent accidents.
Setting Up the Music Stand
(HP-7)
1.
Grasping the music stand with both hands, lift it
toward you until its in the upright position.
2.
Use the support on the back of the music stand to
keep the stand in place.
The angle of the music stand can be set to any of three
positions.
fig.mu_stand
HP-3 HP-7
HP-7 Rear
Speaker cable
Speaker connector
Clip portion
Speakers
1
2
HP-7/3_e.book 10 ページ ２００４年１月２６日 月曜日 午後５時１分